Well since Z-hat is now listing a price of $155/100 for 06 cylinder brass does anyone know of another source????? The Howell basic brass is long enough and cheaper but the necks are thinner and my custom dies don't make it tight enough even without an expander. I then have to take a second step to tighten the neck.

Call Huntington Die Specialty.

http://www.huntingtons.com/cases_howell.html

Oops, missed the part about the Howell basic not working too well.

quote:

Oops, missed the part about the Howell basic not working too well

I do use it but I simply have to run it through a collet die on my 380PDK. If I had cut my dies from Howell brass it would have been fine. By the way you can get it directly from AHR cheaper that huntington.

I have not tried the Howell in my 400PDK if I have to I'll go to z-hat but would love to save a couple $$.

Any ideas???