The Accurate Reloading Forums
6.5x55 Swede load help

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/1341075322

04 August 2016, 23:44
Orange1948
6.5x55 Swede load help
Anybody have any experience using the Hornady 142 gr ELD Match in their Swede? I have a HOWA 1500 Swede and would like to work up some loads using this bullet.
Thanks,
Duane
05 August 2016, 17:57
Snellstrom
I have no experience with that bullet, my swede likes 140 and 142 Sierra Matchkings which are similar to your bullet.
My load is 43 to 44 grains of IMR 4350 seated at 3.03" overall. I use WW or CCI primers and Speer brass. Very accurate.
Good luck with yours.
06 August 2016, 04:29
scottfromdallas
Close.


143 ELD-X, Lapua Brass, CC Magnum primers, 3.10" overall length.

45 H4350- 2675 FPS
45.5 H4350- 2710 FPS



06 August 2016, 06:02
Orange1948
Thanks guys. Have some 142 Sierra's loaded and will get the ELD Matchs loaded and post results.I have heard the ELD Match Bullets are too new to be included in Quick Load yet.
06 August 2016, 23:26
Andre Mertens
My Carl Gustav M96, anno 1901, likes 140 SMK / N 140 / 44.0.



André
DRSS
---------

3 shots do not make a group, they show a point of aim or impact.
5 shots are a group.
15 August 2016, 17:17
slugslinger
I have not tried the ELD bullets. I do however, load 140g Accubonds with Reloder 23 (Rel-23 is a close cousin to Rel-22 only with better temperature insensitivity and copper fouling eliminators). My Sako 85 likes 45-46g of Rel-23, but that is near maximum in the Nosler table so I would start much lower and work your way up.

(Editorial note: my preliminary testing with Reloder 23 and some of the Hodgdon Enduron powders indicate that the CFE characteristic is not hype - it really works. I am seeing significantly reduced copper fouling. I have not tested the temperature insensitivity, but these new powders seem to be a good step in the right direction)


NRA Endowment Life Member
USAF Veteran
17 August 2016, 03:35
Nakihunter
You have a modern rifle that will handle 62000 psi or 54000 CUP pressure for this cartridge.

So you have the option to use modern powders and get performance similar to a 7mm08 with 140 gr bullets.

My Sako & Winchester Mod 70 rifles in 6.5X55 did well with powders like H4350, VV N160, Re 19 and IMR 4831.

It was easy to get very accurate loads up to 2700 fps and top velocity pushing 2800 fps was possible.

I settled on medium power loads around 2700+ fps for 5 shots in less than 1 inch at 100 meters.

Since you bullet is not familiar to me, I will not give you exact powder charge but you should be able to get my kind of results quite easily.

NOTE: Many reloading manuals will have similar velocity with lower powder charge in M96 rifles. But look carefully and you see that the rifles have 29 inch barrels!


"When the wind stops....start rowing. When the wind starts, get the sail up quick."
27 September 2016, 03:24
Bbear
I haven't tried the ELD Match bullet. I have tried the 142 ABLR w/ a dose of IMR4350 and got this result - 4 shot group @ 100 yards.




When a strong man armed keepeth his palace, his goods are in peace - Luke 11:21
Suppose you were an idiot... And suppose you were a member of
Congress...But I repeat myself. - Mark Twain