Guys, I was told last week by my oncologist that I am probably down to months. To that end:

I have been casting bullets since 1980, and have accumulated over 30 H&G commercial moulds. Most of them are eight and ten cavity, but a few are fours and an occasional six. Some of these moulds (a few) are collector grade, but all are serviceable and will out-live you with proper care.

I have moulds for everything under the sun, and would like for them to go to "a good home". I am not even sure what all I have but if there is something you would like to have, please send me a PM. I will make you the best deal I can. In effect, I am trying to have a "living estate" sale while I can before the weakness sets in.

Regards to all my friends here on AR, and thanks for looking.

Do you have any molds and sizing dies for a .351 Winchester S. L.?

Hitman, no, I am sorry. I do not. I have a mould that could probably be made to work, but nothing specifically for the WSL.

The only thing I have even close that might work is a mould for the old 38-200, and it would have to be sized down about .005". I have done this without a problem, but a lot of folks get squeamish doing so. And to be truthful, 200 grains is heavier than the original 180 load.

Sorry...

Thanks for checking.

I have sent you a PM.

If that's the .38-200 round nose like .38 Super Police I'd love to purchase it so it can keep on casting. Please PM me.

P.M. sent

Could I Be lucky enough to find you with any H&G Rifle moulds ??? Nate

Not a lot, but maybe a couple. What specifically are you looking for? Shoot me a PM...

PM sent.

PM returned...