Hi all, I picked up a POS 32 rimfire revolver.



It's missing the trigger, main spring and grips. I'm thinking of converting it to centerfire and shooting some small black powder loads out of it. The bore slugs .304x.320 so I'm thinking of beagleing the OF LEE soupcan 6 holer and makeing a bunch of air coold boolits to fit it. A 32 short colt will chamber in it.

You're braver than I. If I just had to shoot that thing, I'd use buckshot. 00 oughta work. Might need to run it through a sizer.

Now that's a good idea, I'll have to see if I can pickup a bag. Is there anyplace online that sells it cheap?

Mostly done.

I made a trigger, main spring and grips. The nose on the cylinder was all corroded so I drilled the cylinder pin hole out and soldered a bushing in place, then turned to fit. I still need to make a cylinder pin latch. I soldered a centerfire pin in the hammer so I'm almost ready for some 32 short colts in it. I need to find a screw for the grips.

I have bought some old broken revolvers.
The break tops are not strong.
The latch stretches.
The others, like yours, can take big pressure, but the timing is usually not so good.

I have a hard time getting the right parts out of gun parts corp.

I have never made grips.
Sometimes I mix up black expoxy to patch holes or broken grips.