THE ACCURATERELOADING.COM HOG HUNTING FORUM


Moderators: Whitworth
Go
New
Find
Notify
Tools
Reply
  
hog bullet in .44 mag
 Login/Join
 
One of Us
posted
I have never hunted hogs but will in January.
Is a Hornady 240 XTP an adequate for hogs up to 150 pounds. This would be shot from a 6" 44 mag at about 1300 fps.

Thanks


NRA Patron member
 
Posts: 2656 | Location: Minnesota | Registered: 08 December 2006Reply With Quote
One of Us
posted Hide Post
I imagine it will work fine, I've shot quite a few with my S&W 29, a few with factory 240 gr but mostly with 200 gr or 240 gr hard cast...all worked as advertised.


Karl Evans

 
Posts: 2954 | Location: Emhouse, Tx | Registered: 03 February 2010Reply With Quote
one of us
Picture of DesertRam
posted Hide Post
Assuming you place it appropriately, that bullet/cartridge combo will work just fine. Have fun on your first hog hunt!


_____________________
A successful man is one who earns more money than his wife can spend.
 
Posts: 3308 | Location: Southern NM USA | Registered: 01 October 2002Reply With Quote
one of us
posted Hide Post
No pigs permitted here in NY State but premium 44 bullets that work very well on deer and would work on pigs also are Barnes all copper and one of the Swift A-frame. Accurate and effective !
 
Posts: 7636 | Registered: 10 October 2002Reply With Quote
one of us
posted Hide Post
Should kill them dead.
 
Posts: 19835 | Location: wis | Registered: 21 April 2001Reply With Quote
one of us
posted Hide Post
I forgot , but the loads I used were factory loads ! Not the highest pressure [for the sake of my older M29] Speer loads them a bit hotter.
That's another option for those who don't handload .
 
Posts: 7636 | Registered: 10 October 2002Reply With Quote
Moderator
Picture of Whitworth
posted Hide Post
They should work fine. I prefer the 300 grain XTP -- better if you happen upon a mature boar.



"Ignorance you can correct, you can't fix stupid." JWP

If stupidity hurt, a lot of people would be walking around screaming.

Semper Fidelis

"Building Carpal Tunnel one round at a time"
 
Posts: 13440 | Location: Virginia | Registered: 10 July 2003Reply With Quote
One of Us
posted Hide Post
The Hornady 240 gr. is exactly the load I use on them out of a S&W 629 and a Ruger M77/44. Works Goot! Just sold the M77/44 a couple months ago so totally dependent on the 629 and a .22 Mag rifle!
 
Posts: 159 | Registered: 05 August 2006Reply With Quote
One of Us
posted Hide Post
I do not have a 44, I do have a 41. I hunt black bears and not pigs. I would never again use any jacketed hollow point on a bear. Should I ever hunt a pig, my load would be a maximum charge under a hard cast, flat metplate bullet. Same as a bear.
 
Posts: 289 | Location: Western UP of Michigan  | Registered: 05 March 2007Reply With Quote
Moderator
Picture of Whitworth
posted Hide Post
quote:
Originally posted by youp50:
I do not have a 44, I do have a 41. I hunt black bears and not pigs. I would never again use any jacketed hollow point on a bear. Should I ever hunt a pig, my load would be a maximum charge under a hard cast, flat metplate bullet. Same as a bear.


Whiteatail is pretty much the only game I use hollow-points on with revolvers anymore, even then, only sometimes. Hardcast nearly always gets the nod for me as well.



"Ignorance you can correct, you can't fix stupid." JWP

If stupidity hurt, a lot of people would be walking around screaming.

Semper Fidelis

"Building Carpal Tunnel one round at a time"
 
Posts: 13440 | Location: Virginia | Registered: 10 July 2003Reply With Quote
one of us
posted Hide Post
quote:
Hardcast nearly always gets the nod for me as well.


I have shot a few over 300lb hogs with 315gr WFN hard cast works very well.
 
Posts: 19835 | Location: wis | Registered: 21 April 2001Reply With Quote
one of us
posted Hide Post
The 240 gr. XTP from the .44 Magnum should work fine. While I lived in Texas I shot a few with a 240 gr. Sierra JHP from a Ruger .45 Colt Blackhawk with a maximum load of IMR-4227. It killed the hogs easily, but the bullet did not appear to be expanding much. I think the XTPs work better, but they were not around when I was hunting hogs. I shot a lot more with a 7x57 and 139 gr. Hornady bullets. I killed about 30 hogs and they seemed to not take a lot to kill, even the big ones.
 
Posts: 781 | Registered: 03 January 2004Reply With Quote
one of us
posted Hide Post
About any bullet within reason from a 44 mag will kill a hog..The reputation of hogs being tough to kill has not been my experience, they don't have armour plate over the shoulders as some profess..I have killed many of them with a 22 L.R. hollow point, and many with a .222, 45 colt, 357 mag. and other pistol cartridges..Your right on track.


Ray Atkinson
Atkinson Hunting Adventures
10 Ward Lane,
Filer, Idaho, 83328
208-731-4120

rayatkinsonhunting@gmail.com
 
Posts: 42298 | Location: Twin Falls, Idaho | Registered: 04 June 2000Reply With Quote
one of us
Picture of Bobby Tomek
posted Hide Post
That bullet should do fine for what you describe. My favorite in the .44 was the 320 grain Cast Performance WFN LBT-style slug with the wide, flat meplat. My next favorite was the 250 grain Partition. I killed them with others in the .44 Mag but switched to the Cast Performance projectiles after I saw a 300 grain XTP separate on the shoulder of a 175 pound fallow buck, stunning him but far from dispatching him. (I put another through the lungs to finish him off).

Ray is right in that hogs may not be all that difficult to kill or wear "armour," but anyone who's killed and processed plenty of them will understand that the cartiligous shield can be formidable for an improper bullet. Plus, big boars are stoutly constructed.

Check out the body structure on this boar (and notice the caked-on mud):




In the photos below, you can actually see the outline of the "shield" under the hide of the medium-sized boar. The white layer in the other photo (from same boar) is what is sometimes referred to as "gristle" or the "shield" but is actually heavy cartilage. It is not soft like fatty tissue and can certainly test the mettle of an inappropriate projectile.





Bobby
Μολὼν λαβέ
The most important thing in life is not what we do but how and why we do it. - Nana Mouskouri

 
Posts: 9452 | Location: Shiner TX USA | Registered: 19 March 2002Reply With Quote
One of Us
posted Hide Post
great pics and thanks for all the advice guys


NRA Patron member
 
Posts: 2656 | Location: Minnesota | Registered: 08 December 2006Reply With Quote
Moderator
Picture of Whitworth
posted Hide Post
quote:
Originally posted by Bobby Tomek:
That bullet should do fine for what you describe. My favorite in the .44 was the 320 grain Cast Performance WFN LBT-style slug with the wide, flat meplat. My next favorite was the 250 grain Partition. I killed them with others in the .44 Mag but switched to the Cast Performance projectiles after I saw a 300 grain XTP separate on the shoulder of a 175 pound fallow buck, stunning him but far from dispatching him. (I put another through the lungs to finish him off).

Ray is right in that hogs may not be all that difficult to kill or wear "armour," but anyone who's killed and processed plenty of them will understand that the cartiligous shield can be formidable for an improper bullet. Plus, big boars are stoutly constructed.

Check out the body structure on this boar (and notice the caked-on mud):




In the photos below, you can actually see the outline of the "shield" under the hide of the medium-sized boar. The white layer in the other photo (from same boar) is what is sometimes referred to as "gristle" or the "shield" but is actually heavy cartilage. It is not soft like fatty tissue and can certainly test the mettle of an inappropriate projectile.





Yup. This is why I try to always make the distinction between mature boars and all others. They certainly can be tough on bullets. I don't use 240 bullets often in the .44 Mag because it does a whole lot better with 300 + grainers.



"Ignorance you can correct, you can't fix stupid." JWP

If stupidity hurt, a lot of people would be walking around screaming.

Semper Fidelis

"Building Carpal Tunnel one round at a time"
 
Posts: 13440 | Location: Virginia | Registered: 10 July 2003Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia