The Accurate Reloading Forums
Anyone have a Gemsbok Pedestal Mount?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/1411043/m/817103393

28 December 2005, 05:15
TrademarkTexan
Anyone have a Gemsbok Pedestal Mount?
I'm trying to decide the height to make a pedestal for a Gemsbok Shoulder Mount.

I'd like the eyes of the Gemsbok to be about eye level...can anyone that has a Gemsbok on a Pedestal measure the length from the top of the pedestal to the (animals) eyes?


Use enough gun...
Shoot 'till it's dead, especially if it bites.
28 December 2005, 05:29
mstarling
We had Christmas dinner today because everyone could get home. Is a rare and wonderful event ... but folks are pooped. Will have to measure the mount for you tomorrow;




Mike

--------------
DRSS, Womper's Club, NRA Life Member/Charter Member NRA Golden Eagles ...
Knifemaker, http://www.mstarling.com
28 December 2005, 06:41
bo-n-aro
34 inches should work.
28 December 2005, 07:00
TrademarkTexan
quote:
Originally posted by bo-n-aro:
34 inches should work.


34 inches from top of pedestal to the eye of the Gemsbok?


Use enough gun...
Shoot 'till it's dead, especially if it bites.
28 December 2005, 07:31
vapodog
I'm making one just like this for my Gemsbok. The pedistal is 29" from the floor.


///////////////////////////////////////////////////////////////////////////
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery."
Winston Churchill
28 December 2005, 17:16
mstarling
Mine measures 27" from the top of the pedestal to the center of the Gemsbock's eye. He was not a big fella with only 35" horns.


Mike

--------------
DRSS, Womper's Club, NRA Life Member/Charter Member NRA Golden Eagles ...
Knifemaker, http://www.mstarling.com
28 December 2005, 17:53
Rusty
Mims Reed, aka Harry, of this forum has a couple of beautiful mounts. Perhaps, he can post them again!


Rusty
We Band of Brothers!
DRSS, NRA & SCI Life Member

"I am rejoiced at my fate. Do not be uneasy about me, for I am with my friends."
----- David Crockett in his last letter (to his children), January 9th, 1836
"I will never forsake Texas and her cause. I am her son." ----- Jose Antonio Navarro, from Mexican Prison in 1841
"for I have sworn upon the altar of god eternal hostility against every form of tyranny over the mind of man." Thomas Jefferson
Declaration of Arbroath April 6, 1320-“. . .It is not for glory, nor riches, nor honours that we are fighting, but for freedom - for that alone, which no honest man gives up but with life itself.”
28 December 2005, 18:16
TrademarkTexan
quote:
Originally posted by mstarling:
Mine measures 27" from the top of the pedestal to the center of the Gemsbock's eye. He was not a big fella with only 35" horns.


Just what I wanted to know...thanks!


Use enough gun...
Shoot 'till it's dead, especially if it bites.
28 December 2005, 19:17
Widowmaker416
I finished 2 pedestals a few months ago, a Kudu and a Zebra

The Kudu pedestal from the floor to the top of the pedestal measured 26 inches, that put the eye level even with yours, (if your 5'10 inches to 6' tall). I would say a Gemsbok would be close to the same, maybe go 3 inches taller on the pedestal base.





"America's Meat - - - SPAM"

As always, Good Hunting!!!

Widowmaker416
28 December 2005, 20:01
Jerry Huffaker
I just measured your form and it is 30" from where the brisket sets on the base to the top of the eye socket.


Jerry Huffaker
State, National and World Champion Taxidermist



28 December 2005, 20:17
Widowmaker416
Good Jerry!

So from the floor to the eyes with a 28 to 30 inch base would make it 58 to 60 inches, eye level!

There you go! Perfect!





"America's Meat - - - SPAM"

As always, Good Hunting!!!

Widowmaker416
28 December 2005, 20:20
TrademarkTexan
quote:
Originally posted by Jerry Huffaker:
I just measured your form and it is 30" from where the brisket sets on the base to the top of the eye socket.


Thanks, Jerry. I was sitting around figuring my angles and measurements last night and didn't want to call you that late. I think the top of the pedestal will end up right at 36" which will put the eyes at about 5'-6".


Use enough gun...
Shoot 'till it's dead, especially if it bites.
29 December 2005, 02:17
Rusty
Mims ask me to post these pictures for him.





Rusty
We Band of Brothers!
DRSS, NRA & SCI Life Member

"I am rejoiced at my fate. Do not be uneasy about me, for I am with my friends."
----- David Crockett in his last letter (to his children), January 9th, 1836
"I will never forsake Texas and her cause. I am her son." ----- Jose Antonio Navarro, from Mexican Prison in 1841
"for I have sworn upon the altar of god eternal hostility against every form of tyranny over the mind of man." Thomas Jefferson
Declaration of Arbroath April 6, 1320-“. . .It is not for glory, nor riches, nor honours that we are fighting, but for freedom - for that alone, which no honest man gives up but with life itself.”
29 December 2005, 02:34
Harry
Thanks Rusty,
I don't have walls tall enough to put these folks so I had them put on pedestals so I can place them in the house where and on what I want. They are also "fixed" where they will hang on a wall when and if I get a trophy room and want to make a change.
Better tomorrows and Happy New Year to all AR members.
See you in Dallas, Reno and Houston with Tuffpak and other toys!


You can borrow money but you can not borrow time. Go hunting with your family.