08 January 2006, 23:16
DigitalDan#1 question
Have a #1 with Keplinger trigger that was incorrectly set up by the 'smith...set trigger function quit working because it was out of rig apparently. After a bit of fiddling it turned out the trigger had to be removed to free the set screw on the back side due to loc-tite. Long story short, the Safety Arm Pivot Pin drifted out easily enough but is not returning home so gracefully. Any tips on this before I break something? The pin has steps in diameter, the largest and final step being the issue. Tried some gentle heat on the seat to no avail... HELP!
09 January 2006, 00:54
smedleyDigitalDan,
You might try moving this thread over to the "gunsmith" forum. I would think someone over there may be help ya out.
Smedley
______________________
Smedley
______________________
From Audacity of Hope: 'I will stand with the Muslims should the political winds shift in an ugly direction.'
B.H.Obullshitter
------------------------------------
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"
Winston Churchill
------------------------------------
"..it does not require a majority to prevail, but rather an irate, tireless minority keen to set brush fires in people's minds.." Samuel Adams
------------------------------------
Facts are immaterial to liberals. Twisted perceptions however are invaluable.
------------------------------------
We Americans were tired of being thought of as dumb, by the rest of the world. So we went to the polls in November 2008 and removed all doubt.....let's not do it again in 2012 please.
09 January 2006, 01:34
DigitalDanThere's a thought...will do.
09 January 2006, 03:46
DigitalDanUnregard...it helps if you put it in from the correct side....
There is an advantage to NOT having a bigger hammer.
