The Accurate Reloading Forums
Any ideas on what this is or was? Martini?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9421043/m/1171030281

13 November 2012, 07:52
npd345
Any ideas on what this is or was? Martini?
I picked this up at a Gun Show several years ago. I think it is some variation of a Martini action but I really do not know.

The "action" has been placed "into" a .22 caliber barrel.

The barrel is chambered for 22 long rifle' rimfire.

The sides of the "action and the drop lever have been jeweled.

It has a very crisp trigger of obvious high quality.

It extracts and ejects very well.

There is no provision for a thru bolt to mount a stock. however, the barrel bore has been opened up behind were the action is mounted and there may be enough there to thread the hole and mount a thru bolt there?

There are no markings on the barrel or the action.

Has anyone seen a project like this?

Any comments, ideas would be greatly appreciated!!















13 November 2012, 08:22
gwahir
Appears to be a vickers martini. It used a one piece stock, like a bolt action. The hole in the rear of the receiver was for a receiver sight. I have not seen one with the action built into the barrel.
13 November 2012, 08:45
npd345
Thanks! i will see if I can pull up some pictures of a Vickers martini.

I am trying to picture how to stock this and make it look right.

The barrel has been dovetailed for a front sight and there is a spot were the bluing has been removed to (souder?) a rear sight.
13 November 2012, 09:12
npd345
quote:
Originally posted by gwahir:
Appears to be a vickers martini. It used a one piece stock, like a bolt action. The hole in the rear of the receiver was for a receiver sight. I have not seen one with the action built into the barrel.


You nailed it!!

I pulled up pictures on the internet and there is no doubt in my mind that this started out its life as a Vickers Martini.

Thanks!!
13 November 2012, 20:24
Heym SR20
http://www.rifleman.org.uk/Vickers_Martini_rifles.htm

It appears that the stock is attached via that front screw - some examples of take down in the above link
13 November 2012, 21:58
mete
Heym, thanks , that explains it all .
13 November 2012, 22:15
npd345
quote:
Originally posted by Heym SR20:
http://www.rifleman.org.uk/Vickers_Martini_rifles.htm

It appears that the stock is attached via that front screw - some examples of take down in the above link


that was a very helpful link. thanks!
Shane