13 January 2009, 23:43
browntREM 700 ADL
Is it possible to turn a "ADL" into a "BDL"?
Thanks for any input
13 January 2009, 23:48
Jim KobeYes, but you will need the bottom metal and a new magazine box unless you want to make the original one shorter.
If you also mean the stock, that too can be done with some work.
14 January 2009, 00:06
browntThanks Jim, I was just referring to the action. I wasn't sure if holes were the same or if the mag just wouldn't fit.
14 January 2009, 00:44
CheechakoI just recently shortened an ADL box for a BDL fit and it takes CAREFUL planning otherwise you'll screw it up for sure. It has to fit both the floor plate and the receiver,
at the same time.
Probably best to simply buy a new box.
14 January 2009, 00:54
tiggertateUnless you get lucky on an auction its pretty pricey. OTOH, you can buy Williams steel or stainless bottom metal and have a really nice look; better than factory but still drop-in to a BDL stock.
14 January 2009, 18:33
Jim Kobequote:
Originally posted by Cheechako:
I just recently shortened an ADL box for a BDL fit and it takes CAREFUL planning otherwise you'll screw it up for sure. It has to fit both the floor plate and the receiver, at the same time.
Probably best to simply buy a new box.
Au contrire, monsieur!
The magazine and action/bottom metal fit must be close, but should not be so close to bind the two. You should be able to "wiggle" the mag box a tiny bit to ensure there is some relief when it is assembled.