The Accurate Reloading Forums
Cleaning the brown crud off after bluing?

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/9381017991

18 April 2014, 19:31
Chuck Nelson
Cleaning the brown crud off after bluing?
How do you clean the brown crud left over from caustic blueing off of a rifle? I've wiped most of it off with hoppes, but the nooks and crannies are becoming a pain in the neck. Apparently I only paid for half of a job. Thanks.
19 April 2014, 05:06
Craftsman
You might try some Shooters Choice bore solvent. Work it in with a soft bristle tooth brush then wipe with a soft cloth.

To get the splotchy brown off polished surfaces and get a better, more even look, polish with ATF and a brown paper bag.


Craftsman
19 April 2014, 05:20
Chuck Nelson
Thanks. Someone suggested immersing it in boiling water. Thoughts on that?
19 April 2014, 06:25
srose
The crud is because it wasn't properly boiled out after blueing. If you have a tank big enough, boil for about an hour and then soak in a water soluble oil. 0000 steel soaked in 30 W motor oil will scrub blueing without damaging it.
19 April 2014, 09:01
Bobster
Or better yet, don't hot blue. Rust blue and steam for 10 minutes.

www.rustblue.com
19 April 2014, 22:51
Chuck Nelson
I got it clean with time, solvent (hopes) and a rag. It had been cleaned, but only where visible. No thanks on the rust blue and if I posted who did this caustic blue I'm sure there would be a couple of strokes.
20 April 2014, 01:19
ramrod340
quote:
The crud is because it wasn't properly boiled out after blueing

tu2 If they didn't boil it out good then you are likely to have some more work it's way out of the barrel action threads.


As usual just my $.02
Paul K
20 April 2014, 01:28
Craftsman
In my area the water is hard and full of contaminats. When you boil out your bluing work it must be with distilled water or rain water, otherwise after 5 to 10 minutes of boiling you will have rust spots everywhere.

Beware of using a certain brand of water soluble oil on your guns as it tends to leave brown varnish like spots on it and it is very hard to get off. I find ATF to work very well. Mineral oil is good too but costs more.


Craftsman
20 April 2014, 09:55
Chuck Nelson
Colour was good.
20 April 2014, 14:40
pennfly
Did you give the person who did your blue job the opportunity to make it right?
20 April 2014, 18:57
Chuck Nelson
quote:
Originally posted by pennfly:
Did you give the person who did your blue job the opportunity to make it right?


It would cost more time and money than it would be worth. He didn't miss it. He just didn't bother to clean up after himself and thought I wouldn't notice.