The Accurate Reloading Forums
1903 Springfield Action ??

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/84910005

22 July 2003, 12:44
vigillinus
1903 Springfield Action ??
When the 1903 was designed the Army was used to the Krag with its supersmooth working action. It was not possible to make the 1903 quite as slick but they did their best and as a result the prewar rifles are easier to work in rapid fire than an 1898 Mauser. The Mauser handles gas escape better and has a one piece firing pin so is theoretically a little safer and stronger in design than the 1903. NOntheless I feel that the operating ease of the 1903 makes up into a better sporting rifle, especially if you stick to the '06 and its variants, .270, .35 Whelen, etc.
23 July 2003, 05:52
JLHeard
 -

This is a .338 Winnie that I had built up on a 1903 action. I've only been able to shoot it once but it shot nice. BTW, Mike Scherz of Gila River Custom Guns (928.580.0976) in Yuma, AZ (Micheal S. of our forums) was the gunsmith who did the work.

[ 07-23-2003, 02:26: Message edited by: JLHeard ]
23 July 2003, 06:22
frank d
Some nice looking rifles.......

Keep them coming.....

Thanks
Frank D
23 July 2003, 11:50
Agunner012
What alterations other than drill and tap for a scope has to be done to the 1903 Action to sporterize it assuming you want to use a scope at all?

Agunner012
23 July 2003, 13:27
GrandView
quote:
Originally posted by Agunner012:
What alterations other than drill and tap for a scope has to be done to the 1903 Action to sporterize it assuming you want to use a scope at all?


Low-safety.....either an abbreviated arc as the original (pictured on the fine sporter shown in the previous post), or a "side-swing" like a Win model 70...

Modified bolt handle.....either forge the original or weld on new...

The above two modifications are required for clearance on a modern scope mount.

Typically an after-market adjustable trigger is also used as replacement for the military version.

GV
23 July 2003, 13:44
Agunner012
Any idea what that work would cost? Approx?

Agunner012
23 July 2003, 16:17
GrandView
quote:
Originally posted by Agunner012:
Any idea what that work would cost? Approx?


From ER Shaw.....

forge bolt handle..... $40
supply and install Timney safety..... $30
supply and install Timney trigger..... $45

GV
23 July 2003, 22:24
Agunner012
Thanks GrandView, sounds reasonable too.
23 July 2003, 23:07
frank d
Thanks again for all the great info and pictures.....What an education, and a great forum!!!!!!