The Accurate Reloading Forums
Cartridge blueprints!!

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/7551017621

13 February 2010, 03:32
butchlambert
Cartridge blueprints!!
I just received a 419 page binder of reamer prints from Dave Kiff. It has both wildcats and factory prints. It is a steal for $45.
Butch
13 February 2010, 04:47
D Humbarger
Butch does it have the 375 JDJ?



Doug Humbarger
NRA Life member
Tonkin Gulf Yacht Club 72'73.
Yankee Station

Try to look unimportant. Your enemy might be low on ammo.
13 February 2010, 05:53
butchlambert
Doug,
Unfortunatily I haven't figured out to orient the book, but I don't see it.
Butch
13 February 2010, 06:55
ramrod340
Aren't the JDJs Proprietary?


As usual just my $.02
Paul K
13 February 2010, 07:17
Duane Wiebe
I'm sure Kiff would do it right..but gotta ask...are these prints to SAAMI/CIP specs (where applicable)
13 February 2010, 07:37
butchlambert
That is a good question.
Butch
13 February 2010, 21:10
Jim_Dubell
Each print is indicated as to its source, SAAMI, CIP, the original designer, etc. If it is a set of Kiff dimensions he specs that too.

Ahead of the index is a section on bore/groove specs with cross-sectional bore area. It also lists groove width, number of grooves and common twist rates.

Some of the calibers have blank spaces in a couple of catagories where information was not standardized.

If you use any of Daves reamers, these are the dimensions he builds to. It's a dandy reference.
14 February 2010, 04:38
D Humbarger
quote:
Aren't the JDJs Proprietary?



Just how long does a cartridge remain "Proprietary"? Indefinately?



Doug Humbarger
NRA Life member
Tonkin Gulf Yacht Club 72'73.
Yankee Station

Try to look unimportant. Your enemy might be low on ammo.