26 November 2015, 00:13
DickRecoil pad on Vanguard
Friend brought me a weatherby vanguard and wished to change the recoil pad. removed the screws and it appears that the pad is also glued on. without stock destruction any suggestions on how to remove the pad. very thin pad on a 338 Winchester mag. a bit brutal. any help appreciated.
thankx Dick
26 November 2015, 01:38
farbedoWhich stock does it have? If you simply put a thicker pad on, it will change the length of pull. You may need/want to trim the stock to keep the same length of pull. No need to remove the pad in this case, you are cutting it off anyway. May not matter, but something to keep in mind.
On wood, you can use a hair dryer or heat gun to heat up the pad and soften the glue. Option 2, for fiberglass or wood, put it in the freezer, pull it out and then give the pad a hit from the side with a punch and hammer. They usually pop right off.
Last resort, grind the whole thing off with a disc grinder.
Jeremy
26 November 2015, 01:59
speerchucker30x378I cut right down the center of the Bakelite plate on the pad with the band saw. Then grind the remaining 1/32nd off on the belt sander.
My anger management classes have not cured me of that little quirk !

26 November 2015, 20:13
Toomany Toolsquote:
Originally posted by speerchucker30x378:
I cut right down the center of the Bakelite plate on the pad with the band saw. Then grind the remaining 1/32nd off on the belt sander.
We do it the same way here. Easy...if you have the right tools.
27 November 2015, 00:02
dpcdI do it like Speer does too.
27 November 2015, 03:01
Toomany ToolsWhen you cut, keep as close to stock as you can without touching as lots of pads, all Pachmyer as far as I know, have a metal plate imbedded in them.
27 November 2015, 20:23
reindeerProbably not glued on but installed while stock finish was not fully cured. I had the same with my identical Howa 1500. Gently tap the but plate with something appropiate on the top end of
the stock and it will come off eventually
28 November 2015, 05:04
speerchucker30x378quote:
Originally posted by Toomany Tools:
When you cut, keep as close to stock as you can without touching as lots of pads, all Pachmyer as far as I know, have a metal plate imbedded in them.
Actually I like those the best John. I use my metal saw and just tip the cutting head upright. When I hear the blade hit the steel plate I just take a quick turn to the inside, next to the wood and get the blade running along the side of the metal plate. When the pad is off the cut is so straight that it looks like it was done by a magician. Don't do it with a wood blade of course.