Michael-

Tally does not make stainless rings. Do you know of someone who makes a similar ring that fits your bases in stainless?

Would the rings work if I had them plated?

Any thoughts?

The bases I received look very nice. I like the wide base and the sculpted border. At first I thought the recoil shoulder arrangment seemed a bit strange but it looks real good on the rifle and one shoulder is certainly sufficient for anything 375 and under. The extra width makes the receiver contouring a little more critical but adds stability once everything is set up well. I like them. Regards, Bill.

BTT

This is the way they should have been done in the first place. Very nice indeed!

Normally I can figure these things out but this time I'm stumped. What's BTT? Also you have PM.

Tig,

BTT is Bringing This to Top i.e resurrecting a thread to current view.

PM is Private Message. You need to check your "My Home" page on AR.

jim dodd

Thanks on BTT. I was actaully sending him a PM but thanks anyway... my post did appear confusing in that regard.

Michael,
Have you considered incorporating a ghost ring peep sight into the recoil shoulder of the rear base ? One that would move side to side for windage and matched to an NECG adjustable banded front sight. That would be super slick for a DGR.