Looking for a Barrel Band for a 375 Whitworth

The Accurate Reloading Forums

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/180100652

25 April 2005, 22:38

Rusty

Looking for a Barrel Band for a 375 Whitworth

I'm looking for one of these.

If you have one for sale please contact me at
rkmojo@aol.com
or post a reply!

25 April 2005, 23:03

Mark

Hmm, looks like a Michaels or similar swivel for a Win 94 or Marlin 336? What is the OD of the barrel?

for every hour in front of the computer you should have 3 hours outside

26 April 2005, 01:21

RCG

Check out www.brownells.com They are listing Talley and London Guns barrel bands.

Also, I believe NECG may carry some as well.

Good luck.

RCG

26 April 2005, 18:24

Rusty

Mark, RCG,
Thanks for your input. the Uncle Mike's stuff is too small and has a dished out top for mounting under the barrel of a tubular magazine rifle.
the NECG, Talley and London guns require soldering.
The original just slips off the barrel after removal of the front sight.

Once again, thanks!

Rusty
We Band of Brothers!
DRSS, NRA & SCI Life Member
"I am rejoiced at my fate. Do not be uneasy about me, for I am with my friends."
----- David Crockett in his last letter (to his children), January 9th, 1836
"I will never forsake Texas and her cause. I am her son." ----- Jose Antonio Navarro, from Mexican Prison in 1841
"for I have sworn upon the altar of god eternal hostility against every form of tyranny over the mind of man." Thomas Jefferson
Declaration of Arbroath April 6, 1320-“. . .It is not for glory, nor riches, nor honours that we are fighting, but for freedom - for that alone, which no honest man gives up but with life itself.”

26 April 2005, 20:22

Atkinson

The fully enclosed barrel bands can be cut and slipped past the front sight. and then glassed to the barrel and done right look very good and seem to work very well. I suppose one could also d & T them with a tiny plug screw...

The one you show will sure as hell slip and cause you all sorts of problems, at least they did with me...I believe its because they have no taper and are disigned for a magazine tube....For what its worth.