The Accurate Reloading Forums
1903 Turk, so far (pics - lots)

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/9411043/m/15610125

16 November 2003, 04:08
TGetzen
1903 Turk, so far (pics - lots)
-

-

-

-

-

-

It is actually much smoother than it looks, the flash is highlighting tiny surface marks. All edges are stoned straight and sharp, and flats are flat. It is ready for barreling, then bluing. I am considering something very cool for the front ring and left rail - more later if it works.

Todd
16 November 2003, 04:15
wallyw
Nice work Todd. Are you planning on a scope? What caliber?
16 November 2003, 05:31
Nitroman
Ok Todd, no more guns for you... [Smile]
16 November 2003, 07:08
cummins cowboy
how do you think this turk stacks up to some of the other mauser actions, nice work keep us updated
17 November 2003, 06:37
TGetzen
quote:
Originally posted by Nitroman:
Ok Todd, no more guns for you... [Smile]
Herd has been significantly thinned of late... Yugos, Turks other than 1903's, various unexciting VZ models, commercial rifles, etc -- all gone. Remaining are a few nice custom Mauser sporters, two European Mauser sporters, and some nice / uncommon military Mausers. Still a couple more to sell, too.
17 November 2003, 06:39
TGetzen
RE: this Turk vs other Mausers, it stacks up very well. It was made at Oberndorf at the height of their excellence. Finding a 1903 Turk in the relatively excellent shape this one was is another story, however.

Todd
17 November 2003, 06:44
TGetzen
One more thing that's cool about this rig, which you probably can't see in the pics -- that's a commercial proofed Oberndorf bolt, in fantastic shape (bolt face looks unfired). Not sure what exactly it is from, but it is the proper type of bolt for a 1903 Turk / 1909 Peruvian. The bend is factory, which is the confusing issue -- neither of them should have a factory bent bolt as far as I know.

Todd
17 November 2003, 07:28
D Humbarger
Thats a very clean Turk Todd. What caliber is it going to be? Please keep us updated on your progress with this project.
17 November 2003, 11:53
uwave
Todd

I like those Turk 03 actions also. I like the look of the high charger clip hump along with the longer receiver ring.

All of the 1903 Tuk actions that I have seen have the front ring undercut to provide a lip to hold the rear of the handguard. I beleive this undercut was done by the Turk arsenals. If you surface grind the receiver ring to remove the turk crest (here I assume your action had a front ring crest) it looks like the lip will be removed because it is pretty thin. Did you remove the lip from the front? Could you please post pictures of the front of the receiver ring?

Keep adding updates and pictures for this topic so I can use it for refernce material when I attempt to clean up my Turk 03 actions.