The Accurate Reloading Forums
Lawson Recoil Pad

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/7971019521/m/6701057381

31 December 2012, 19:45
Mike in Michigan
Lawson Recoil Pad
I'm looking for a recoil pad that is deep-dished in the center...looks like an old crescent shaped Winchester butt plate. I have a Lawson in for stock restoration and the original pad is rock hard and crumbling around the edges. I would like to keep the original lines if possible. The original pad has the waffle vents on the sides, is red with white spacer. Any help would be greatly appreciated. BTW, the stock end measures 2 15/16 by 5 1/8 inches.


Mike Ryan - Gunsmith
01 January 2013, 04:20
richj
Lawson Harry Gunsmithing Co
3328 N Richey Blvd
Tucson, AZ 85716-1412

Phone (520) 326-1117
02 January 2013, 18:52
Mike in Michigan
Wrong Lawson. The rifle I am working on was built by Harry Lawson back in the 60's or 70's.


Mike Ryan - Gunsmith
02 January 2013, 20:16
zimbabwe
I believe you will find that to be the correct address. I think it is now run by the son of the founder.


SCI Life Member
NRA Patron Life Member
DRSS