The Accurate Reloading Forums
Pondering...

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/6121043/m/23310729

27 July 2002, 13:12
Paul H
Pondering...
The mention of using a 30 mauser sizer in the 22 DLH thread got me to thinking. Could the 30 mauser die be used with a 38 sp / 357 mag to make a modern rook rifle round? We don't have a single shot rifle forum, and some of the most creative wildcatters post here.
27 July 2002, 13:50
cas
How long of a case? The 30-357 is supposed to be a great little setup in lever guns/
27 July 2002, 13:51
<Headstamp>
Paul,

The 30 Mauser die is a bit bigger in diameter than a 38/357 case in the body. I use it for first pass forming when I was playing around with the 221 rimmed and making regular 221 cases from 223/222, etc.

You would probably need a die that matched the case dimensions better for the final sizing for proper chambering.

For first pass forming, you can get away with using the Mauser die bacause the 38/357 case centers itself when it hits the shoulder area of the Mauser die. Then on into a 256 trim die which fits the whole case better.

You MAY be able to get away with something like using the 30 Mauser die for neck sizing and a shoulder bump and using a 357/38 carbide sizer die to size the body of the case.

Regards

[ 07-27-2002, 04:54: Message edited by: Headstamp ]
29 July 2002, 14:38
<Headstamp>
http://talk.shooters.com/room_54/1179.cfm
29 July 2002, 14:41
<Headstamp>


[ 07-29-2002, 17:49: Message edited by: Headstamp ]