The Accurate Reloading Forums
308 Win. Rem 700 /krieger 100yds open sight target

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/3221043/m/7951028532

08 October 2017, 23:34
shootaway
308 Win. Rem 700 /krieger 100yds open sight target
I shot this from the bench at 100yds yesterday.

I was using a Krieger 1-13t heavy Palma barrel,155gr Hornady molly coated boat tails,Vit 140 powder.

The chamber was cut with my new Palma Manson reamer.

It took three rds before the rifle settled.

I also moved the sight elevation down a bit while shooting to adjust.

So far I've gotten this barrel super hot a couple of times.

Kriegers are very accurate.

[URL= ]100yds open sight off the bench[/URL]
[URL= ]a[/URL]
[URL= ]b[/URL]
09 October 2017, 09:55
waterrat
Jesus Christ,,you must be the worst shot in North America!!


I tend to use more than enough gun
09 October 2017, 17:03
p dog shooter
quote:
Jesus Christ,,you must be the worst shot in North America!!


Or Canada he is in Montreal after all.

But then with my old eyes I couldn't do better with open sights.

I don't even try shooting them any more.
09 October 2017, 17:33
Fury01
Or; a surviving member of the honest target tribe. Few survivors left in a the internet world. Lots of rounds in that paper.


"The liberty enjoyed by the people of these states of worshiping Almighty God agreeably to their conscience, is not only among the choicest of their blessings, but also of their rights."
~George Washington - 1789
09 October 2017, 18:18
shootaway
After it settled and I had the sight adjusted, it was shooting every round in the centre.I was using a bunch of rounds loaded with new brass mixed in with once fired.I had mixed loads/rds up last time out and therefore had to load some new rounds.You can see the first three rounds fired.There the ones spread out most.

It may be hard to see from my pics but I did the job of opening the barrel channel myself.This in order for the stock to be able to fit the barrel.It doesn't look that nice.There is also a piece of the stock broken off around the safety lever.This is the third one I broke.It comes from trying to remove the barrelled action from the stock without removing the bolt beforehand.
09 October 2017, 18:48
Ghubert
quote:
Originally posted by shootaway:
After it settled and I had the sight adjusted, it was shooting every round in the centre.I was using a bunch of rounds loaded with new brass mixed in with once fired.I had mixed loads/rds up last time out and therefore had to load some new rounds.You can see the first three rounds fired.There the ones spread out most.

It may be hard to see from my pics but I did the job of opening the barrel channel myself.This in order for the stock to be able to fit the barrel.It doesn't look that nice.There is also a piece of the stock broken off around the safety lever.This is the third one I broke.It comes from trying to remove the barrelled action from the stock without removing the bolt beforehand.



You guys are being trolled senseless! Big Grin