Hi
I own some very good Voere actions machined here in Argentina and am looking to construct a 9,3x64 rifle .
After reading a lot of past answers I am in the dificult to decide the twist rate that must have the barrel and also what do you think about this project.
I also own four different 9,3x 62 rifles and are very pleased of them.
Thank´s to all of you who answer
Guillermo Trotz

Guillermo,
use the same twist as in your 9,3x62's. You will be shooting the same bullets.

regards,

Rich
DRSS

gtrotz I built my 9.3x64 with a 1-12in twist and I have been very pleased.It shoots the 250 gr,270 gr 286 gr and the 293 gr bullets very well. All group under an inch at 200 yds.I have not tried any 320 gr bullets. Hope that helps

Thank´s
I really apreciate your answers .
After reading some more and your answers my choice is betwen a douglas or a lothar walter barrel in 24 " .
This will take 4 or 5 months to realize if I could get the barrel promptly here.
When I finish I will put some photografs here
Sincerely
Guillermo Trotz