The Accurate Reloading Forums
Need help with the .338 Win.

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/3221043/m/262104121

05 March 2004, 06:27
joecool544
Need help with the .338 Win.
Thought I might be able to save some time with this and just ask. What powders are you using for the .338 win mag and what can of velocity are you getting with 225 and 250-grain bullets. Thanks
05 March 2004, 06:40
Terry Blauwkamp
For the 225 gr, I use 70 gr of IMR 4350 for 2700 fps.

For the 250 gr I use 69 gr of Rel 22 for 2650.

I don't like 4831 in the 338 mag, as it takes up too much room, and causes one to have to compress the powder a lot.
05 March 2004, 06:49
ramrod340
I use H414
05 March 2004, 08:25
kutenaymtnboy
I use RE-22 with 250s, exclusively in my 5 rifles in this caliber. I load from 75-77 grs. with 250 Partitions, Partition Gold Moly Free and Hornady Spire Points.

This is functional max. and "over book", so start at 69 grs. and work up, carefully, velocities run about 2725-2775 depending on rifle and the conponent lot(s).

I might add that I used 4350 for 20+ yrs. and still prefer it with 225 Pts. I see no reason for light bullets in magnum rifles or using more than one bullet weight. I prefer the Partition Gold M.F. to any other available bullet.
05 March 2004, 10:18
rifleman1
For 225 NAB or 225 SGS - 73 IMR 4350 - 2850 fps
05 March 2004, 10:32
hm2
70 grains of 4350 with a nosler 210 part = 2900, the same load with a 225 = just a little over 2800.
05 March 2004, 14:23
joecool544
Thanks for the replies that will save me bunch of time and money.
05 March 2004, 14:31
NBHunter
Another voter for plain old H4350. I have a favorate load using Rel22 with 250gr. bullets but the powder doesn't care that much for temperature changes. Make life simple and stick with one powder that will work well with all. My loads are basically right from the books. Funny, my hunting load has never been chrony'd, it is copied from the Barns manual using the 225g X and 4350. The book says 2700 fps and change, all I know is that I shot 2 groups with it the first time out and they were 1-1.25" and I said good enough, and loaded the rest of them.
05 March 2004, 18:03
BFaucett
This is not a max velocity load or an attempt to develop one. It�s basically a factory velocity duplication load. It does have very consistent velocities and good accuracy.

Cartridge: 338 Win Mag
Firearm: Ruger M77 MkII
Barrel: 24"
Bullet Make: Nosler Partition
Bullet Weight: 250 grs
Powder: IMR-4831
Powder Weight: 69.0 grs
Case Make: W-W
Primer: WLR (not magnum primer)
C.O.L.: 3.30

Chronograph
Shot#, Velocity fps
1, 2,649
2, 2,651
3, 2,654
4, 2,633
5, 2,645
6, 2,651
7, 2,664
8, 2,644
9, 2,656
10, 2,658

Summary
Average Velocity: 2,651
High Velocity: 2,664
Low Velocity: 2,633
Extreme Spread: 31
Standard Deviation: 8
06 March 2004, 03:50
Antlers
Quote:

70 grains of 4350 with a nosler 210 part = 2900, the same load with a 225 = just a little over 2800.




Is this H4350 or IMR4350??
06 March 2004, 12:10
hm2
i'm sorry. that is h4350
07 March 2004, 04:59
thirtycal
I use IMR 4350 69g with a Sierra 215g gameking at about 2750fps, just shoot paper with it so far and shoots less than 1/2 in @100yds. Three shot groups all shots touch almost always, It has a BOSS on it and I tuned the BOSS to my Handload. Most accurate rifle I own.
07 March 2004, 07:24
Ray, Alaska
I use RL19 with 225 and 230-grain bullets, and RL-22 with bullets from 240 grains to 300 grains.
08 March 2004, 03:02
bowhuntrrl
I use IMR4350 in my .338 Win Mag. I use a 210 Nosler Partition at 3050 fps out of my 26" barrel. With this load, there is no need to use anything heavier, IMHO!!! You would have to see how it knocks down an elk to believe it!

bowhuntr
10 March 2004, 08:11
djpaintles
225 Accubond, 71.0 IMR-4350, 2800fps, Elk 515yds dead.
10 March 2004, 16:20
Phil T.
With 250 grain bullets, I use Hodgdon's load of 71.5 grains of H4831 Short Cut.
For 225 and lighter, my rifle prefers 74 grains of Alliant Reloader 22. This powder charge is lighter than the max charge Alliant publishes, but my chronograph says I'm getting the top velocity.
The first powder I tried was IMR 4350, but the recoil was very sharp and uncomfortable. Slower powders "push" more than "jab".