like most of you my loading bench is getting quite crowded. Looking over it yesterday I thought of a swivel mount for my 2 powder measures. easy mount. took a couple pieces of 3/8x2 aluminum flat bar 15" long. drilled a 1" hole in one end and a 3/8" in the other. Drilled a hole through near the edge of the bench and bolted the flat bar through it - with 2 fender washers between the wood and the bar. The washers act as a sort of a bearing. Now the measures swing to the side out of the way when not in use, but swing out from the bench a foot to give more hand room around them.

Thanks for sharing. Who said this forum was dead. A little slower with age , perhaps. roger