I worked with Gordon’s Reloading Tool, but I am not sure that I did it right. I am looking for a starting point with a 375 Taylor, or the 375/338 Win Mag. I am asking for several powders, so I can offer a little boot for the work. Do you need Cast Performance 360 grain .452 bullets or Barnes .458, 450 grain triple shocks? Also 45LC, 38spl., 45ACP, or 40 S&W pin tumbled brass?
So run the 375-338 or 375 Taylor, with a 22” barrel, using Barnes 300 grain TSX, for these powders: IMR-4064, RL-15, W760/H414, H4895, H4350, LeverRevolution, CFE223, Varget and H380.

More info needed:

Water capacity of fired cases, trim to length and COAL.

Jiri

I have been told that this is a menu cartridge in Quickload. I am double checking.

375/338 Chatfield-Taylor.

if you want the sheet PM your email

Thanks a bunch. PM sent.

quote:

Originally posted by Arniet:
I have been told that this is a menu cartridge in Quickload. I am double checking.

I mean water capacity of your brass fired from your chamber, trim to length you use and COAL you use for this bullet.

This is necessary for simulation to be as accurate as possible.

Using standard values is easy, but often not accurate.

Jiri

I have not finished the build yet. I am just looking for a starting point. Later, I will have more info, but my plan is to start low and work up till I get 2500 fps with a 300 grain Barnes, or the lever (BLR) gets sticky.

The simulation confirmed, that at least 2 powders I have in stock would be good starting points. They are CFE 223 and H414/W760. Looking trough all the data RL17 might be better, but that is the only one I did not think of. Plus, I don't have any.

Thanks again to RICHJ.