Thanks Paul.
------------------
[This message has been edited by PC (edited 01-18-2002).]
Your rockchucker should have a removeable bushing that you can take out and replace with another, that will let the 585 dies thread into. I have to change bushings to load my 500 Jeff.
Sooner
You could always use a chainsaw and a blowtorch...
The RCBS press has a screw in insert for the bigger 1 inch dies that are needed for 585, 500 Jeffrey, 505 etc.
For trimming, a file/trim die might be the answer.
These are simply dies where excess case length sticks out the top and you run a file across it, but the die is not hurt since it is too hard to file.
Mike