The Accurate Reloading Forums
Big Bore Neck Reamers

This topic can be found at:
https://forums.accuratereloading.com/eve/forums/a/tpc/f/2511043/m/2801075082

18 February 2025, 00:23
thecanadian
Big Bore Neck Reamers
Does anyone know of any options for neck turners on cases greater then 50 cal? Seems that both Peterson and Jamison are a wee bit thicker then the Bertram brass I set up my reamer for. Or should it just be easier/cheaper to ream out the neck portion of the chamber.


"though the will of the majority is in all cases to prevail, that will to be rightful must be reasonable; that the minority possess their equal rights, which equal law must protect, and to violate would be oppression."

---Thomas Jefferson
19 February 2025, 06:49
Lamar
might be easier to get an inside reamer rather than a neck turning unit for one that big.

IIRC you can order them in .001 steps.
19 February 2025, 18:03
Live Oak
A mini lath from Harbor Freight or some other soarce.
19 February 2025, 21:45
thecanadian
quote:
Originally posted by Lamar:
might be easier to get an inside reamer rather than a neck turning unit for one that big.

IIRC you can order them in .001 steps.



"though the will of the majority is in all cases to prevail, that will to be rightful must be reasonable; that the minority possess their equal rights, which equal law must protect, and to violate would be oppression."

---Thomas Jefferson
19 February 2025, 21:46
thecanadian
quote:
Originally posted by thecanadian:
quote:
Originally posted by Lamar:
might be easier to get an inside reamer rather than a neck turning unit for one that big.

IIRC you can order them in .001 steps.


I think that's probably going to be my best bet


"though the will of the majority is in all cases to prevail, that will to be rightful must be reasonable; that the minority possess their equal rights, which equal law must protect, and to violate would be oppression."

---Thomas Jefferson