THE ACCURATE RELOADING DIY FORUM

Go
New
Find
Notify
Tools
Reply
  
How I defeated "moly"
 Login/Join
 
One of Us
posted
Have had these moly coated bullets for awhile & wanted to remove coating, I tried 5 month soak in Kroil (nothing), tumbling in media (moly hardened), then soak a few minutes in "Dad's EZ Spray Paint & Varnish Remover" (water rinse), rinsed again in hot tap water, spread out on paper towels to dry in oven at low heat and now ready to use, r in w.
 
Posts: 557 | Location: Wenatchee, Washington | Registered: 26 April 2012Reply With QuoteReport This Post
One of Us
posted Hide Post
Yep , good idea Ray , I just may have to try
that myself .
Bob


DRSS Chapuis 9.3 x 74 R
RSM. 416 Rigby
RSM 375 H&H
 
Posts: 1291 | Location: Catskill Mountains N.Y. | Registered: 13 September 2011Reply With QuoteReport This Post
one of us
posted Hide Post
Thank you I soaked some I ended up with in Mineral spirits and tumbled in treated walnut and got some off, but in to the paint remover they will go to finally get them clean.

Thanx again.
Louis



Don't limit your challenges . . .
Challenge your limits


 
Posts: 4223 | Location: TN USA | Registered: 17 March 2002Reply With QuoteReport This Post
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia