THE ACCURATERELOADING.COM KNIVES AND KNIFE MAKING FORUM


Moderators: Saeed
Go
New
Find
Notify
Tools
Reply
  
Engraving Help
 Login/Join
 
one of us
Picture of ramrod340
posted
I have a Buck 110 that was given to me 40+ years ago by a customer. He had my name engraved on the end of the handle. However he left the last N off my name. It bugs me every time I use it and it is my go too.

If I was to buff it off is there someplace I can send it to have my name added back correctly?

I'm a couple hundred miles away from it or I would post a pic. There is simply not room (I think) to add the letter even if it could be matched.


As usual just my $.02
Paul K
 
Posts: 12881 | Location: Mexico, MO | Registered: 02 April 2001Reply With Quote
One of Us
posted Hide Post
I've spelled "Ramrod340" several different ways but still cannot figure out where you'd put an "N".

Just hackin' on ya Paul.

Good luck in your quest,
Zeke
 
Posts: 2269 | Registered: 27 October 2011Reply With Quote
one of us
Picture of ramrod340
posted Hide Post
rotflmo rotflmo

Darn you made me laugh so hard my sides hurts.

Thanks. coffee


Maybe I should get Mrs Clause to order me a new custom from Buck and retire the old one.

Yes I know there are 100s of great knifes out there but I just lean towards the folder other than a little skinning knife with gut hook.


As usual just my $.02
Paul K
 
Posts: 12881 | Location: Mexico, MO | Registered: 02 April 2001Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia