08 March 2014, 01:49
ELeetonKnife Kit Assembly
Is there anyone out there who assemblies the various knife kits offered for sale? I have my eyes on a Delta 5 Chute knife and don't have much more than a hammer and drill to put it together.
Eric
14 March 2014, 01:27
DenisBAdd a file & some gritpaper to the drill & its eminently doable with a bit of elbow grease.
Hammer is largely superfluous to needs.
An anglegrinder with sanding disc or dremel tool with sanding drums will speed up the task , but they are by no means necessary equipment to achieve a good result.
14 March 2014, 20:35
Wes62A small drill press, various rasp and files, and some sandpaper of various grits will do a fine job.
18 March 2014, 04:10
Vol717I've built a few knives and in my opinion it is just about the dirtiest job to grind down the handles to size. I screwed and glued the handles in place and tried various ways of shaping them. Best way I found was a tight flap disk on a grinder. That method removed material rapidly and coated my shop with the dust. After that knife I set up a vice on a post and did my shaping outside. I'll buy my knives readymade, thank you.