THE ACCURATERELOADING.COM FAVORITE LOADS FORUM


Moderators: Saeed
Go
New
Find
Notify
Tools
Reply
  
.338-'06 loads for 200 and 225 grain bullets
 Login/Join
 
One of Us
posted
I see widely varying recommendations for loading this caliber. I am shoting Ruger 77 Mrk. II with 23" barrel - 1 in 10" twist.

I'd like to develop loads for 200 and 225 grn. loads. Any suggestions are appreciated.

AT
 
Posts: 872 | Location: S. E. Arizona | Registered: 01 February 2019Reply With Quote
One of Us
posted Hide Post
Two of my most accurate loads.
200 gr Hornady or Nosler 55 gr. varget Rem 9 1/2 primer Rem case 2700 fps.

225 Sierra or Nosler 60 gr. 4451 Win primer, Rem case or
64 gr. Superformace these loads were about 2650 fps.

24" barrel.
 
Posts: 304 | Location: Minnesota | Registered: 12 February 2007Reply With Quote
One of Us
posted Hide Post
Thank you, sir!
 
Posts: 872 | Location: S. E. Arizona | Registered: 01 February 2019Reply With Quote
one of us
Picture of D Humbarger
posted Hide Post
200 gr nosler bt with 56.0 gr imr 4320 23"bbl. 2750fps

200 gr hornady with 55.0 gr R15 2635 fps

200 gr hornady with 56.0 gr varget 2750 fps

185 gr barnes ttsx with 55.5 gr H4895 2820 fps

225 hornady with 52.0 gr R15

225 gr hornady with 55.0 gr imr 4320

200 gr nosler bt with 56 gr imr 4320

210 gr barnes ttsx with 58.0 gr R17 2565 fps

All these loads shot under 1 inch in my rifles.

Either Remington 7600 or a FN400. Both rifles have Lothar Walther 23 1/2" barrels.

Use at your own risk.



Doug Humbarger
NRA Life member
Tonkin Gulf Yacht Club 72'73.
Yankee Station

Try to look unimportant. Your enemy might be low on ammo.
 
Posts: 8342 | Location: Jennings Louisiana, Arkansas by way of Alabama by way of South Carloina by way of County Antrim Irland by way of Lanarkshire Scotland. | Registered: 02 November 2001Reply With Quote
One of Us
posted Hide Post
Thank you Doug. Much appreciated.
 
Posts: 872 | Location: S. E. Arizona | Registered: 01 February 2019Reply With Quote
One of Us
posted Hide Post
 
Posts: 359 | Location: Corpus Christi,Texas | Registered: 19 April 2004Reply With Quote
One of Us
Picture of dpcd
posted Hide Post
That book seems light; just start there and work up for your rifle like anything else.
I just started with this caliber a couple of weeks ago and like it; no recoil but lots of power. And I load for the 338 Lapua and RUM too; basically half the powder but 90% of the velocity. Something like that. Very efficient.
 
Posts: 17046 | Location: USA | Registered: 02 August 2009Reply With Quote
One of Us
posted Hide Post
Many thanks to all who shared loads. Very helpful.

AT
 
Posts: 872 | Location: S. E. Arizona | Registered: 01 February 2019Reply With Quote
one of us
posted Hide Post
I found the 200 gr. bullet neither fish nor fowl, preferring to use it in my 30-06 or a 300 magnum in that you gain sufficient length of bullet as to SD..

The 225 gr. is a total different story, it was a marriage made in heaven on deer and elk, at least with most available bullets Ive used..I really like the 225 Accubond or partition for deer and elk, mostly elk, but where I hunt elk, chances of a monster Mule deer are always taken into consideration..I use a stiff load of RL-19 as a rule both for velocity and accuracy..RL-22 being my second choice..Ive used this combo on a number of elk. those two bulls killed with a 200 gr. Accubond in my fwt mod. 70 30-06, that worked as well as my 338-06 IMP or 9.3x62...As usual the 06 holds its own...


Ray Atkinson
Atkinson Hunting Adventures
10 Ward Lane,
Filer, Idaho, 83328
208-731-4120

rayatkinsonhunting@gmail.com
 
Posts: 41762 | Location: Twin Falls, Idaho | Registered: 04 June 2000Reply With Quote
One of Us
Picture of Snellstrom
posted Hide Post
The 225 grain Sierra Pro Hunter is a very tough bullet and works great on Everything I've shot with it. Sometimes hard to get but worth it.
I took it to South Africa in my 338 Win Mag and killed Zebra, Kudu, Wildebeest, Warthog, Impala, Blesbok, Bushbuck. Recovered one bullet from the Wildebeest, all others were pass throughs.
That bullet weighed 206 grains after passing through more than 3 feet of muscle and bone.
In a 338/06 it would be good for anything.
 
Posts: 5603 | Location: Eastern plains of Colorado | Registered: 31 October 2005Reply With Quote
One of Us
posted Hide Post
Thanks!
 
Posts: 872 | Location: S. E. Arizona | Registered: 01 February 2019Reply With Quote
one of us
posted Hide Post
Ive shot all the AFrican PG and two buffalo with a 338 Win. I like the 225 and 250 gr. Accubonds..So I suspect the 338-06 would do as well..but in my opine he 210 Nosler partition is a marriage made in heaven on big game of any kind in a 338-06 and the .338 Win. fits the 225 Accubond and heavier..


Ray Atkinson
Atkinson Hunting Adventures
10 Ward Lane,
Filer, Idaho, 83328
208-731-4120

rayatkinsonhunting@gmail.com
 
Posts: 41762 | Location: Twin Falls, Idaho | Registered: 04 June 2000Reply With Quote
One of Us
Picture of mustbhuntn
posted Hide Post
I have a similar rifle, Ruger 77 Mrk II with a 24" Shilen barrel. I struggled to find an acceptably accurate load. After trying damn near every .338 bullet made (slightly exaggerating) I found that 58.5 gr of IMR4350 and a 250gr Hornady Interlock round nose shot 1.5 inch groups at 200 yards giving about 2400 fps. Sighted dead on at 200 yards, its 11 inch low at 300 yards. I'm comfortable out to 300 yards. With that said, I hardly ever exceed 200 yard shots on big game. I have taken several deer and about 10 elk with this load when I lived in Idaho. None of the elk required a second shot. 338-06 is always an excellent choice.
 
Posts: 321 | Location: Green Forest, Arkansas | Registered: 24 March 2007Reply With Quote
  Powered by Social Strata  
 


Copyright December 1997-2023 Accuratereloading.com


Visit our on-line store for AR Memorabilia