27 October 2020, 14:01
SaeedVideo Of Our 150 Gr 0.308 Caliber Bullet
150 gr Walterhog SolidThe video is of our 150 grain solid.
The target was actually shot with the exact same bullet, but with a hollow point.
Same program, I only disabled the drilling part, as someone asked for solids, when I took the video.
It is not something I like to do very often, as I have to disable the coolant, so that I can take a video.
I run the machine at a slower speed, then adjust it in software to normal speed afterwards.
I do this to avoid damage to the cutting tools.
Rifle was a Robler Titan 6.
Load was 47 grains of VARGET and Federal 210M primers in RWS brass.
5 shots at 100 yards in our underground shooting range.
13 November 2020, 21:20
packrattusnongratusThanks Saeed. I still do .224 jacketed, 357 lead, and .429 jacketed bullets from Corbin dies. Your bullets are the bee's knees. Be Well, Packy.
16 November 2020, 07:26
carpetman1Saeed, I would think in Dubai that automobiles rusting is a problem. If you know someone that does auto body work, they could use those filings from your lathe. Body putty comes in two parts--the putty and the hardener. If you mix those filings in the putty and then add the hardener it will fill a large hole easier than putty alone. It can be sanded easily.
03 March 2021, 10:01
waterratOutstanding Video,,very cool,,Thanks!
04 March 2021, 00:48
Brian CanadaGreat video, Thanks. Brian
05 March 2021, 04:25
clayman216Nicely done. Will you use that bullet to hunt ?
10 March 2021, 18:14
Saeedquote:
Originally posted by clayman216:
Nicely done. Will you use that bullet to hunt ?
Yes.
This is the same basic design I made years ago.
I make all calibers from this design, and have hunted with them extensively.
Others have taken them all over the world.
They work very well, just any of the commercial mono metals.
If anyone tells you any kills better than others, he is lying!
13 March 2021, 21:02
clayman216Yes that sounds right. Since I have been using the Barnes TSX I have become a believer. Well built Monos are as good as it gets in my opinion.
25 March 2021, 22:10
Kolo-PanI don't know about that bullet but I sure would like to have that machine plus the knowledge to use it!
what does it cost to make each bullet?
15 November 2021, 21:26
WstrnhuntrCNC tec is da bomb! Maybe I should try making some on my mini-lathe.
Cool video Saeed.