Here is how I make things feed; look at it when it is doing what you don't want it to do. Look through the situation and you can see what will need to be done to change it's behavior. A slow motion camera can work. Then, make the change required to the steel. It is either intuitive, or impossible, for some to envision. One possibility is that the maker made the feed rails too wide, but that is a complete guess.
Bobster, the bolt starts to pick up the round and the round moves a little and then bolt slides over the top of the case. If you stop the bolt and pull it back then restart the bolt forward again it will feed.
Posts: 11 | Location: Wyoming | Registered: 11 October 2021
Apparently, it is a bullet nose issue. Take some Dykem or a blue Sharpie and color the feed rail on the left side and any ramp in front of it. Cycle and look for the contact point(s). Stone that area until you get it to feed.
Originally posted by MAC08: Bobster, the bolt starts to pick up the round and the round moves a little and then bolt slides over the top of the case. If you stop the bolt and pull it back then restart the bolt forward again it will feed.
Posts: 3236 | Location: SC,USA | Registered: 07 March 2002
Originally posted by MAC08: Hipshoot, Have you figured anything out or just dealing with it?
So far I've been just dealing with it. It has gotten a little bit better as the rifle was shot very little. I have been double clutching it a bit like you. The front of my feed rails have been worked on but perhaps not enough.
Posts: 1225 | Location: Long Island, New York | Registered: 04 January 2008