custom molds
Slowpoke -
Word descriptions are not easy. I'll take another shot at it.
Thanks again.
01 June 2004, 14:11
DE HillyerHi All! Just a little damage from the storms but was up 1/2 the night helping in a nearby town. A little tired- may have to go back to work to rest up!
Well, I am still interested in this mold. The basic concept fits my needs well.If anyone else is, let us continue. If no one else is, I'll have it made special for me.
I still think an experienced person should 'run' this. Those that have done this in the past have done a good job. Any experienced volunteers?
Dale
01 June 2004, 15:43
Slowpoketrk--- The tumble lube groove dimensions from the Lee second edition is --- inside top edge of groove to inside top edge is .040, band width is .010, groove angle is 26 degree's, its just a vee bottom groove.
If there is enough interest to do 25 molds, then I would be glad to collect the checks, place the order and send them out afterwards.
Glenn.
01 June 2004, 18:38
floodgatelar45: If this is a "fat thirty", count me in. Post here or PM me for e-address, etc. floodgate