03 October 2002, 20:39
<AndreKalahari>Casting for the .416 Rem
Dear All
Objective: To cast bullets for my .416 Rem
Challenge: Dies are almost impossible to find in South Africa
Request: Is there anybody out there who are prepared to help me obtain moulds for the .416?
Kind regards
04 October 2002, 09:22
micmacSure,
How hard can it be to UPS a mould to S.A.? What mould are you looking at? Here is an Austrailian Co.who has .416 bullet moulds listed.
http://www.users.bigpond.com/ammodump/cbe.htmlCan't find anything from any of the major US players(Lyman,Lee, Etc)
There is also a company called NEI which is here in Oregon. There single bullet moulds run $70 I believe. Here is their info:
NEI Handtools Inc
51583 Columbia River Hwy
Scappoose, OR 97056-4407
Phone
503)543-6776
[ 10-03-2002, 12:40: Message edited by: micmac ]04 October 2002, 01:31
<AndreKalahari>Thanks for the response
I hope to be able to shoot the 416 more often and to use it for warthog and impala in bush country. My Winchester model 70 is too nice a rifle to use only on the large stuff. Ranges will be less than 100m and a 300 - 350gr bullet at 1800 - 2000ft/s will be more than adequate(?)