01 April 2003, 06:01
stockerLloyd: Lots of luck fnding one. If you can't I recently obtained a mold from Dan at Mountain Molds. It drops wheel weights at 220 grains. Cast 750 bullets with it yesterday for the first go around and it dropped them out like a dream. Lube grooves may be a tiny bit shallow but I think they will shoot just fine. Hope to be shooting some by next weekend. I had him make it to cast close to .351 and he also supplied a .350 sizer and matching top punch.
These bullets will seat with the base of the gas check very close to the base of the case neck.
Dan tries very hard to give you what you want and he will custom make them to your design. Prices are very competitive.
www.mountainmolds.com is the link I believe.